6060 Hwy 7, Markham ON
Office Mon to Fri 9am to 5pm
On site evenings, overnights and weekends
Concrete, Quarry Tile & Entrances
Degreasing and restoration for entrance vestibules, quarry-tile walkways, kitchens and loading areas. These take the most abuse in the building and are usually the first thing anyone sees.
Running this across the GTA since 1991
What is involved
The three things that decide whether this job holds up, rather than looking good for a fortnight.
Hot-water pressure extraction through quarry tile and grout, including under equipment and along drains, where mopping has never reached.
Salt residue etches a finish and leaves a white bloom. Neutralising washes through the season keep it from setting in.
Degreased tile has grip. The aim is a clean floor with its coefficient of friction intact, not a shiny hazard.
Proof
Same room, same lighting, before and after. Drag to compare.
Before
After
Degreased and scrubbed to a polished finish. No new tile. That is the original colour returning.
Before
After
Winter salt damage and worn traffic lanes stripped out, then sealed for the next season.
Before
After
Ground-in soil and adhesive haze across the plank seams, removed and sealed overnight.
Where we run it
The sectors where concrete, quarry tile & entrances comes up on nearly every site.
Often booked with
One contractor across the whole building means these do not need a second company or a second invoice.
01 / 04
Full chemical strip down to bare tile, neutralise, then 4 to 6 coats of commercial-grade finish. Turns grey, built-up VCT back to a wet-look shine.
Learn more
02 / 04
Scheduled deep scrub and 1500 to 2000 RPM burnish to pull scuffs and restore gloss between strip-and-wax cycles. Far cheaper than a full restoration.
Learn more
03 / 04
Final-phase cleaning for new builds and renovations: adhesive and grout haze removal, protective finish, and a hand-off-ready floor.
Learn more
04 / 04
Recurring nightly cleaning and daytime porter coverage for offices, washrooms, kitchens, common areas and waste. Built around your building's schedule and reported through one contact.
Learn moreQuestions about this service
If the answer you need is not here, call us. We would rather talk it through than have you guess at a budget.
Almost never. What looks like permanently dark tile is usually years of grease held in the grout, and pressure extraction takes it out. The quarry tile pair in our gallery is exactly that.
Yes. Kitchen and loading-area work is sequenced after close or between shifts, with the area dry and back in use before the next service.
Entry matting holds the grit that scratches everything past it. We clean it on the same visit, or tell you when it is past saving.
Next step
Send the square footage and floor type, or book a free walkthrough and we will measure it.
